"1,5 " CNS Standards List| Insulation coordination | Bleed Screw | High pressure | Plug Gauge | Knurled Nuts | Ammonium Chloride | Diving equipment | Method test | |
|
CNS 15042
2018 Edition Standard specification for infrared thermometers for intermittent determination of patient temperature 間歇性測定患者體溫之紅外線體溫計 |
|
|
|
CNS 9131
2018 Edition 660V Three-Core Insulated CP Sheathed Metal Netting Covered Cable(660V - TPNC) and 660V Three-Core EPR Insulated CP Sheathed Metal Netting Covered PVC Anti - Corrosion Cable (250V-TPNCY) for Marine Use 船用６６０Ｖ三心ＥＰＲ絕緣ＣＰ被覆金屬網鎧裝電纜（６６０Ｖ–ＴＰＮＣ）及６６０Ｖ三心ＥＰＲ絕緣ＣＰ被覆金屬網鎧裝ＰＶＣ防蝕電纜（６６０Ｖ–ＴＰＮＣＹ） |
|
|
|
CNS 5135
2018 Edition Method of Measurement for Applied Weight of Liquid Adhesives 液狀黏著劑之塗佈量測定法 |
|
|
|
CNS 15562-5
2018 Edition Stationary training equipment − Part 5: Stationary exercise bicycles and upper body crank training equipment, additional specific safety requirements and test methods 固定式訓練器材－第5部：固定式健身單車及上半身曲柄訓練器材之附加特定安全要求與試驗法 |
|
|
|
CNS 5138
2018 Edition Method of Measurement for Softening Temperature of Adhesives 黏著劑之軟化溫度測定法 |
|
|
|
CNS 15588-2
2018 Edition Electric traction - Rotating electrical machines for rail and road vehicles - Part 2: Electronic converter-fed alternating current motors 電力牽引-軌道及道路車輛用之旋轉電機 第2部：電子換流器供電型交流電動機 |
|
|
|
CNS 15200-8-1
2018 Edition Methods of test for paints – Part 8-1: Evaluation of degradation of paint coatings – General principles and rating schemes 塗料一般試驗法－第8-1部： 塗膜劣化評估－一般原則及等級 |
|
|
|
CNS 15037-2
2018 Edition Walking aids manipulated by both arms - Requirements and test methods - Part 2: Rollators 雙臂操作步行輔具－要求及測試法－第２部：帶輪助行器 |
|
|
|
CNS 15590-7
2018 Edition Mechanical properties of fasteners – Part 7: Torsional test and minimum torques for bolts and screws with nominal diameters 1 mm to 10 mm 結件之機械性質－第7部：標稱直徑1 mm至10 mm螺栓與螺釘之扭力試驗及最小扭矩 |
|
|
|
CNS 9137
2018 Edition 250V Single-Core, Twin-Core Three-Core ERR Insulated PVE Sheathed Cable (250V-SPY, 250V-DPY, 250V-TPY) for Marine Use 船用２５０Ｖ單心、二心、三心ＥＰＲ絕緣ＰＶＣ被覆電纜（２５０Ｖ–ＳＰＹ，２５０Ｖ–ＤＰＹ，２５０Ｖ–ＴＰＹ） |
|
|
|
CNS 15620-3
2018 Edition Insulation coordination for equipment within low-voltage system – Part 3: Use of coating, potting or moulding for protection against pollution 低電壓系統下設備之絕緣協調－第3 部：用於污染防護之塗裝、封裝或壓塑 |
|
|
|
CNS 12971-5
2018 Edition Identification cards-Integrated circuit(s)cards with contacts-Part 5:Numbering system and registration procedure for application identifiers 識別卡（具接點之ＩＣ卡）；第５部：應用識別碼的編碼系統與登錄程序 |
|
|
|
CNS 15200-8-2
2018 Edition Methods of test for paints – Part 8-2: Evaluation of degradation of paint coatings – Designation of degree of blistering 塗料一般試驗法－第8-2部： 塗膜劣化評估－起泡等級 |
|
|
|
CNS 15400
2018 Edition Green and roasted coffee − Determination of free flow bulk density of whole beans (Routine method) 咖啡生豆與焙製咖啡豆－咖啡豆自由流動總體積密度測定法(常用法) |
|
|
|
CNS 1
2018 Edition Prevailing torque type hexagon regular nuts (with non-metallic insert) − Property classes 5, 8 and 10 等比標準數 |
|
|
|
CNS 13919
2018 Edition Equipment to perform in-service monitoring on 1544 Kbps signals 服務狀態中監視 1544 Kbps 信號之設備 |
|
|
|
CNS 9156
2018 Edition 250V,Single-Core,Twin-Core,Three-Core,EPR Insulated CP Sheathed Metal Netting Covered Cable 250V Single-Core Three-Core EPR Insulated CP Sheathed Metal Netting Covered PVC Anti-Corrosion Cable for Marine Use 船用２５０Ｖ單心、二心、三心ＥＰＲ絕緣ＣＰ被覆金屬網鎧裝電纜（附共同遮蔽）及２５０Ｖ單心、二心、三心ＥＰＲ絕緣ＣＰ被覆金屬網鎧裝ＰＶＣ防蝕電纜（附共同遮蔽） |
|
|
|
CNS 9157
2018 Edition 250 Twin-Core,Three-Core EPR Insulated PVC Sheathed Metal Netting Covered Cable and 250V Twin-Core, Three-core EPR Insulated PVC Sheathed Metal Netting Covered PVC Anti-Corrosion Cable for Marine Use 船用２５０Ｖ二心、三心ＥＰＲ絕緣ＰＶＣ被覆金屬網鎧裝電纜（附各心線個別遮蔽）及２５０Ｖ二心、三心ＥＰＲ絕緣ＰＶＣ被覆金屬網鎧裝ＰＶＣ防蝕電纜（附各心線個別遮蔽） |
|
|
|
CNS 1352
2018 Edition Method of test for grammage of paper and board 紙及紙板基重試驗法 |
|
|
|
CNS 15612
2018 Edition Plastics − Determination of the melt mass-flow rate (MFR) and melt volume-flow rate (MVR) of thermoplastics − Part 1: Standard method 塑膠－吸水率測定法 |
|
|
|
CNS 15588-1
2018 Edition Electric traction - Rotating electrical machines for rail and road vehicles - Part 1: Machines other than electronic converter-fed alternating current motors 電力牽引－軌道及道路車輛用之旋轉電機－第1部：旋轉電機(不含電子換流器供電之 交流電動機) |
|
|
|
CNS 9153
2018 Edition 660V, Twin-Core, Three-Core EPR Insulated PVC Sheathed Metal Netting Covered Cable and 660V Twin-Core, Three-Core EPR Insulated PVC Sheathed Metal Netting Covered PVC Anti-Corrosion Cable for Marine Use 船用６６０Ｖ二心、三心ＥＰＲ絕緣ＰＶＣ被覆金屬網鎧裝電纜（附各心線個別遮蔽）及６６０Ｖ二心、三心ＥＰＲ絕緣ＰＶＣ被覆金屬網鎧裝ＰＶＣ防蝕電纜（附各心線個別遮蔽） |
|
|
|
CNS 15127
2018 Edition Methods of test for the concentration of gases produced by burning of joss sticks 香品燃燒所產生之氣體測定法 |
|
|
|
CNS 15200-8-5
2018 Edition Methods of test for paints – Part 8-5: Evaluation of degradation of paint coatings – Designation of degree of flaking 塗料一般試驗法－第8-5部： 塗膜劣化評估－片狀剝落 |
|
|
|
CNS 15041-1
2018 Edition Specification for non-invasive sphygmomanometers - Part 1: General requirements 非侵入式血壓計－第１部：一般規定 |
|
|
|
CNS 15499-3
2018 Edition Electrically propelled road vehicles – Safety specifications – Part 3: Protection of persons against electric shock 電動推進道路車輛－安全規範－第3部:預防人員電擊之保護 |
|
|
|
CNS 15457
2018 Edition Methods of measurement on alternating current light emitting diode modules for optical and electrical characteristics 交流發光二極體模組之光學及電性量測法 |
|
|
|
CNS 15609-2
2018 Edition Thermoplastics pipes and fittings − Vicat softening temperature − Part 2: Test conditions for unplasticized poly(vinyl chloride) (PVC-U) or chlorinated poly(vinyl chloride) (PVC-C) pipes and fittings and for high impact resistance poly(vinyl chloride) (PV 熱塑性塑膠管與管件－衛氏軟化溫度－第2部：未塑化或氯化聚氯乙烯管與管件及高耐衝擊聚氯乙烯管之試驗條件 |
|
|
|
CNS 17050-1
2018 Edition Conformity assessment − Supplier's declaration of conformity − Part 1: General requirements 符合性評鑑－供應者之符合性聲明－第1 部：一般要求事項 |
|
|
|
CNS 13597
2018 Edition Office Machines-Line and Character Capacity of Address Masters 事務機器–位址列印裝置之行數與字元容量 |
|
| Find out:4589Items | To Page of: First -Previous-Next -Last | [67] [68] [69] [70] [71] [72] [73] |
