"A " CNS Standards List |
|
CNS 8973
1995 Edition Quenched And Tempered Manganese-Molybdenum and Manganese-Molybdenum-Nickel Alloy Steel Plates for Pressure Vessels 壓力容器用淬火－回火之錳鉬及錳鉬鎳合金鋼鋼板 |
|
|
|
CNS 11378
1995 Edition MAgnetic Particle Test for Welds 銲道磁粒檢測法 |
|
|
|
CNS 7379
1995 Edition CArbon Steel Tubes for Boiler and Heat Exchanger 鍋爐及熱交換器用碳鋼鋼管 |
|
|
|
CNS 7377
1995 Edition SeAmless Steel Tubes for High Pressure Gas Cylinder 高壓貯氣瓶用無縫鋼管 |
Translated |
|
|
CNS 11401
1995 Edition Method of UltrAsonic Test for Steel Butt Welds 鋼對接銲道超音波檢測法 |
|
|
|
CNS 8969
1995 Edition CArbon Steel Plates for Pressure Vessels for Intermediate and Moderate Temperature Service 中、常溫壓力容器用碳鋼鋼板 |
|
|
|
CNS 8971
1995 Edition MAnganese-Molybdenum and Manganese-Molybdenum-Nickel Alloy Steel Plates for Boilers and Pressure Vessels 鍋爐及壓力容器用錳鉬及錳鉬鎳合金鋼鋼板 |
|
|
|
CNS 12874
1995 Edition BAsic Environmental Testing Procedures Part 2:Tests,Test Kb:Salt Mist,Cyclic(Sodium Chloride Solution) 環境試驗法(電氣、電子)－鹽霧(循環)試驗 |
|
|
|
CNS 5009
1995 Edition Woodworking Spindle ShApers 木工用單立軸機 |
|
|
|
CNS 10001
1995 Edition SeAmless Nickel-Chromium-Iron Alloy Tubes for Heat Exchanger 熱交換器用無縫鎳鉻鐵合金管 |
|
|
|
CNS 10003
1995 Edition SeAmless of Nickel-Chromium-Iron Alloypipes for Piping 配管用無縫鎳鉻鐵合金管 |
|
|
|
CNS 1366
1995 Edition Tinned HArd-drawn Single Solid Copper Wire 鍍錫硬銅單電線 |
Translated |
|
|
CNS 13521
1995 Edition Method of Test of SAcrificial Anodes Used for Cathodic Protection 陰極防蝕用犧牲陽極性能檢驗法 |
|
|
|
CNS 13542
1995 Edition Low-voltAge Metal-enclosed Switchgear 低電壓金屬閉鎖型配電箱 |
|
|
|
CNS 6102
1995 Edition Flush PlAtes for Indoor Use 室內用平面蓋板 |
|
|
|
CNS 13543
1995 Edition Method of Test for Low-voltAge Metal-enclosed Switchgear 低電壓金屬閉鎖型配電箱檢驗法 |
Translated |
|
|
CNS 5804
1995 Edition CArbon Steel Pipes for High Temperature Service 高溫配管用碳鋼鋼管 |
Translated |
|
|
CNS 13545
1995 Edition Acoustics - Preferred Frequencies for Measurements 聲學量測上優選的頻率 |
|
|
|
CNS 10471-1
1995 Edition Method of Test for Dirt in PAper and Paperboard 紙及紙板內污點試驗法 |
Translated |
|
|
CNS 5008
1995 Edition Rip SAws 木工用縱鋸機 |
|
|
|
CNS 13551
1995 Edition Bus for A.C. Metal-enclosed Switchgear and Controlgear 金屬閉鎖型配電箱及控制箱用匯流排 |
Translated |
|
|
CNS 2674
1995 Edition LeAd Pipes (For General Purpose) 鉛管（一般用） |
|
|
|
CNS 13567
1995 Edition Method of Test for Sieving of ChemicAl Products 化學製品篩分法 |
|
|
|
CNS 13568
1995 Edition Method of Test for Acid Value,Saponification Value,Ester Value,Iodine Value,Hydroxyl Value and Unsaponificable Matter of Chemical Products 化學製品酸價、皂化價、酯價、碘價、羥價及不皂化物試驗法 |
|
|
|
CNS 13575-3
1995 Edition WheelchAirs - Type Classification based on appearance characteristics 輪椅－依外觀特性分類 |
|
|
|
CNS 9179
1995 Edition GenerAl Rules for Chemical Analysis 化學分析法通則 |
|
|
|
CNS 287
1994 Edition Method of Test for ChemicAl Analysis of Limes 石灰化學分析法 |
|
|
|
CNS 10695
1994 Edition Method of Test for LAnd Mobile Communication FM or PM Receivers, 25-947 MHz (Audio Frequency Response, Harmonic Distortion Factor, Hum and Noise) 陸上行動通信用25-947 MHz調頻／調相接收機檢驗法（聲頻響應、諧波失真因數、交流聲及雜訊） |
|
|
|
CNS 10694
1994 Edition Method of Test for LAnd Mobile Communication FM or PM Receivers, 25-947 MHz (Characteristics of the Measuring Equipment and Reference Sensitivity) 陸上行動通信用25-947 MHz調頻／調相接收機檢驗法（測量設備之特性及基準靈敏度） |
|
|
|
CNS 10693
1994 Edition Method of Test for LAnd Mobile Communication FM or PM Receivers, 25-947 MHz (Definition and Test Condition) 陸上行動通信用25-947 MHz調頻／調相接收機檢驗法（定義、試驗條件） |
|
| Find out:15242Items | To Page of: First -Previous-Next -Last | [443] [444] [445] [446] [447] [448] [449] |
