"Rat " CNS Standards List |
|
CNS 13306-2-3
2019 Edition Specification for radio disturbance and immunity measuring appaRatus and methods - Part 2-3: Methods of measurement of disturbances and immunity - Radiated disturbance measurements 射頻擾動和免疫力量測設備與量測方法－第２－３部：擾動和免疫力量測方法－輻射擾動量測 |
|
|
|
CNS 11030
2019 Edition Overlaid glulam for decoRative use 化粧貼面裝修用集成材 |
|
|
|
CNS 7137
2019 Edition Sine-vibRation testing method for automobile parts 車輛零組件正弦振動試驗法 |
|
|
|
CNS 15062
2019 Edition Paints and varnishes - Testing of formaldehyde-emitting coatings and melamine foams - Determination of the steady-state concentRation of formaldehyde in a small test chamber 塗料－逸散甲醛塗膜與三聚氰胺泡棉試驗法－小型容器中恒定狀態甲醛濃度之測定 |
|
|
|
CNS 15748-3
2019 Edition IntegRated circuits − Measurement of electromagnetic emissions, 150 kHz to 1 GHz – Part 3: Measurement of radiated emissions – Surface scan method 積體電路－150 kHz 至1 GHz 電磁放射量測－第3 部：輻射放射量測－表面掃描法 |
|
|
|
CNS 16121-1
2019 Edition Electrical appaRatus for the detection of combustible gases in domestic premises − Part 1: Test methods and performance requirements 家居處所可燃氣體偵測用之電氣裝備－第1部：試驗方法及性能要求 |
|
|
|
CNS 13306-1-5
2019 Edition Specification for radio disturbance and immunity measuring appaRatus and methods - Part 1-5: Radio disturbance and immunity measuring apparatus - Antenna calibration test sites for 30 MHz to 1000 MHz 射頻擾動和免疫力量測設備與量測方法－第１－５部：射頻擾動和免疫力量測設備－30 MHz至 1000 MHz之天線校正場地 |
|
|
|
CNS 15449-2-101
2019 Edition Safe requirements for electrical for measurement, control and laboRatory use ? Part 2-101: Particular requirements for in vitro diagnostic (IVD) medical equipment 量測、控制及實驗室使用電氣設備安全規定－第2-101 部:體外診斷(IVD)醫用設備之個別規定 |
|
|
|
CNS 15711-1
2019 Edition Photovoltaic (PV) module performance testing and energy Rating − Part 1: Irradiance and temperature performance measurements and power rating 太陽光電模組性能試驗與能量定額－第1 部： 照射度與溫度性能量測及功率定額 |
|
|
|
CNS 14892
2019 Edition Method of test for making, acceleRated curing, and testing concrete compression test specimens 混凝土加速養護試體之製作及試驗法 |
|
|
|
CNS 15066
2019 Edition Solar energy - CalibRation of field pyranometers by comparison to a reference pyranometer 太陽能－比較參考全天空輻射計校正場全天空輻射計 |
|
|
|
CNS 15176-26-1
2019 Edition Wind turbines − Part 26-1: Time-based availability for wind turbine geneRating systems 風力機－第26-1 部：風力發電機系統以時間為基礎之可利用率 |
|
|
|
CNS 15125-1
2019 Edition Solar heating - Domestic water heating systems - Part 1 : Performance Rating procedure using indoor test methods 太陽能加熱－家用熱水系統－第１部：性能評比程序之室內試驗法 |
|
|
|
CNS 12048
2019 Edition Electroplated Coating of Gold for DecoRative Use 裝飾用金電鍍層 |
|
|
|
CNS 15600
2019 Edition Photovoltaic devices - Procedures for tempeRature and irradiance corrections to measured I-V characteristics 太陽光電裝置－量測I-V特性之溫度與照射度修正程序 |
|
|
|
CNS 16093-3
2019 Edition Welding and allied processes − Types of joint prepaRation − Part 3: Metal inert gas welding and tungsten inert gas welding of aluminium and its alloys 銲接及其相關製程－接頭準備型式－第3部：鋁及鋁合金的惰氣遮護金屬電弧銲接及惰氣遮護鎢極電弧銲接 |
|
|
|
CNS 13059-4
2019 Edition Photovoltaic devices - Part 4: Reference solar devices - Procedures for establishing calibRation traceability 太陽光電裝置－第4部：基準太陽 裝置－建立校正追溯性之程序 |
|
|
|
CNS 61400-25-1
2019 Edition Wind energy geneRation systems − Part 25-1: Communications for monitoring and control of wind power plants − Overall description of principles and models 風力機－第25-1部：風力發電廠監控通訊－原理及模型整體描述 |
|
|
|
CNS 9893
2019 Edition Testing methods for rubber vibRation isolators 隔振橡膠試驗法 |
|
|
|
CNS 14432-2
2019 Edition Determination of the ultimate aerobic biodegradability of plastic materials under controlled composting conditions − Method by analysis of evolved carbon dioxide − Part 2: Gravimetric measurement of carbon dioxide evolved in a laboRatory-scale test 塑膠材料在控制堆肥條件下最終好氧生物分解度測定法－二氧化碳釋出量分析法－第2部：實驗室規模重量測定法 |
|
|
|
CNS 15762-7
2019 Edition Footwear − Test methods for uppers – Part 7: High tempeRature behavior of uppers 鞋類－鞋面試驗法－第7 部：鞋面之高溫性能 |
|
|
|
CNS 14410
2019 Edition Test methods of exhaust system exposed surface tempeRature for motorcycles 機器腳踏車排氣系統外露表面溫度試驗法 |
Translated |
|
|
CNS 15748-1
2019 Edition IntegRated circuits − Measurement of electromagnetic emissions, 150 kHz to 1 GHz − Part 1: General conditions and definitions 積體電路－150 kHz 至1 GHz 電磁放射量測－第1 部：一般條件及定義 |
|
|
|
CNS 13306-1-4
2019 Edition Specification for radio disturbance and immunity measuring appaRatus and methods - Part 1-4: Radio disturbance and immunity measuring apparatus - Ancillary equipment - Radiated disturbances 射頻擾動和免疫力量測設備與量測方法－第１－４部：射頻擾動和免疫力量測設備－輔助設備－輻射擾動 |
|
|
|
CNS 15362
2019 Edition Determination of the degree of disintegRation of plastic materials under simulated composting conditions in a laboratory-scale test 塑膠材料在實驗室規模模擬堆肥條件下崩解度測定法 |
|
|
|
CNS 15103
2019 Edition Textiles - Determination of abrasion resistance of fabrics by the Martindale method - Part 1 : Martindale abrasion testing appaRatus 紡織品耐摩損性馬丁代爾試驗法－第１部：馬丁代爾耐摩損試驗機 |
|
|
|
CNS 15059
2019 Edition Liquid petroleum products - SepaRation and characterization of fatty acid methyl esters (FAME) from middle distillates - Liquid chromatography (LC) / gas chromatography (GC) method 中質石油餾分－分離脂肪酸甲酯及其組成測定法（液相層析法／氣相層析法） |
|
|
|
CNS 15030-26
2019 Edition Classification and labelling of chemicals - AspiRation hazard 化學品分類及標示－吸入性危害物質 |
Translated |
|
|
CNS 10798
2019 Edition RefrigeRated display cabinets – Classification, requirements and test conditions 冷凍冷藏展示櫃－分類、要求及試驗條件 |
|
|
|
CNS 15244
2019 Edition Office equipment - Measurement of ozone, volatile organic compounds and dust emissions Rate from copiers, printers and multi-function devices 辦公室設備－複印機、印表機及多功能事務機之臭氧、揮發性有機化合物及粉塵逸散率之量測法 |
|
| Find out:1287Items | To Page of: First -Previous-Next -Last | [10] [11] [12] [13] [14] [15] [16] |
