CNS Standards Solution | HOME | LOGIN | SIGN UP | CONTACT US | 中文版 |
�� ��

Chinese National Standards
中華民國國家標準
- Taiwan 台灣 -
| Ethanol(95 )﹝Ethyl | General Aspects | Casting moulds | Chemical Reagent | Integrated Circuits | Microfilming technical | Chlorinated rubber | Polyester Staple |  

What is CNS Standards ?

CNS Standard is abbreviation of Chinese National Standard, the National Standards of the Republic of China (Taiwan) ;
They are administered by the Bureau of Standards, Metrology and Inspection of the Ministry of Economic Affairs.

The English versions CNS standards were translated directly from the openly-published Chinese CNS standard , in case of any divergence of interpretation, the Chinese versions CNS standards text shall prevail.

CNS standards are divided into 26 numbered categories, Detail see bellow:
  • CNS Standards 26 Categories:
  • CNS Standards Index:
  • C-Electrical Engineering
    CNS 5428 - English Version
    Concentric Plugs and Jacks
    單頭插頭、插口 - 英文版
    N-Agriculture, Food
    CNS 3652 - English Version
    Method of test for edible oils and fats-Cold test
    食用油脂檢驗法-冷却試驗 - 英文版
    C-Electrical Engineering
    CNS 7610 - English Version
    Varnished Glass Bias Tape
    漆斜條玻璃纖維布帶 - 英文版
    B-Mechanical Engineering
    CNS 7564 - English Version
    Flat Countersunk Head Rivets Nominal Diameters 3 to 5 mm
    平頂埋頭鉚釘(皮帶鉚釘),標稱直徑3至5mm - 英文版
    K-Chemical Industry
    CNS 15932-3 - English Version
    Rubber, vulcanized or thermoplastic – Part 3: Determination of adhesion to metal − Two-plate method
    硫化或熱塑性橡膠接著強度試驗-第3 部:與金屬接著-雙板測定法 - 英文版
    C-Electrical Engineering
    CNS 60335-2-52 - English Version
    Household and similar electrical appliances − Safety − Part 2-52: Particular requirements for oral hygiene appliances
    家用和類似用途電器-安全性-第2-52 部:口腔衛生電器之個別規定 - 英文版
    X-Information & Communication
    CNS 14232-7 - English Version
    Health Level Seven (HL7) - Part 7: Observation reporting
    健康資訊交換第七層協定-第7部:觀察報告 - 英文版
    A-Civil Engineering & Architecture
    CNS 11325 - English Version
    Reinforced concrete cable troughs
    鋼筋混凝土製電纜槽 - 英文版
    B-Mechanical Engineering
    CNS 4757 - English Version
    Microindicators
    微動指示錶 - 英文版
    B-Mechanical Engineering
    CNS 15886 - English Version
    Cycles − Hubs and freewheels − Assembly dimensions
    自行車-輪轂與飛輪-總成尺度 - 英文版
    K-Chemical Industry
    CNS 15848-1 - English Version
    Plastics − Determination of water content
    塑膠-微差掃描熱量法(DSC)-第1 部:通則 - 英文版
    C-Electrical Engineering
    CNS 12357 - English Version
    Temperature Limitation of Low Voltage Insulated Wires.
    低壓絕緣電線最高容許溫度 - 英文版
    B-Mechanical Engineering
    CNS 5705 - English Version
    Vane Motors for Hydraulic Use - Diameter 20 - 50 mm
    液壓用輪葉馬達–口徑20~50mm - 英文版
    C-Electrical Engineering
    CNS 9688 - English Version
    Heat-Shrinkable FEP Tubing for Electrical Insulation (Tubular Type)
    電絕緣用熱收縮氟化乙烯丙烯共聚合體套管(管狀) - 英文版
    C-Electrical Engineering
    CNS 9686 - English Version
    Heat-Shrinkable Polyolefin Tubing for Electrical Insulation (Tubular Type)
    電絕緣用熱收縮聚烯烴套管(管狀) - 英文版
    N-Agriculture, Food
    CNS 6503 - English Version
    Spices and Condiments – Pepper, whole or ground
    香辛料及調味料-粒狀或粉狀胡椒 - 英文版
    K-Chemical Industry
    CNS 13380 - English Version
    Hexanes
    己烷 - 英文版
    K-Chemical Industry
    CNS 6361 - English Version
    Method of test for common properties of certain pigments
    顏料中一般性質之檢驗法 - 英文版
    C-Electrical Engineering
    CNS 13802-1 - English Version
    Graphical Symbols for Diagrams (General Informations)
    電機工程製圖符號(一般規定) - 英文版
    B-Mechanical Engineering
    CNS 5965 - English Version
    Bronze Screwed Angle Valves (10kgf/c㎡)
    青銅螺紋口角閥(10 kgf/㎠) - 英文版

    Find out:16168Items   |  To Page of: First -Previous-Next -Last  | [103] [104] [105] [106] [107] [108] [109]


    | HOME | LOGIN | SIGN UP | CONTACT US | 中文版 | ©  CNS-standards.org Copyright  2001-2025 All Rights Reserved
    The authority agency link :
    Bureau of Standards, Metrology & Inspection M.O.E.A.
    This site is not affiliated with or endorsed by the BSMI or MOEA.