"It " CNS Standards List |
|
CNS 5564
2019 Edition Rated Output and Its Test Methods for Automobile Generators 汽車用發電機之額定輸出及試驗法 |
|
|
|
CNS 13059-10
2019 Edition Photovoltaic devices − Part 10: Methods of linearIty measurement 太陽光電裝置－第10 部：線性度量測法 |
|
|
|
CNS 15593-62
2019 Edition ElectricIty metering – Data exchange for meter reading, tariff and load control – Part 62: Interface classes 電力計量－讀表、計費及負載控制之資料交換－第62 部：介面類別 |
|
|
|
CNS 15755-3-2
2019 Edition Conversion tables for unIts − Part 3-2: Area − Square meter and square yard 單位換算表－第3-2 部：面積－平方公尺與平方碼 |
|
|
|
CNS 14934-5
2019 Edition Electromagnetic compatibilIty (EMC) - Limits - Part 5: Limitation of voltage fluctuations and flicker in low-voltage power supply systems for equipment with rated current greater than 16A 電磁相容－限制值－第5部：額定電流大於16 A之設備於低電壓電源系統中電壓變動及閃爍之限制值 |
|
|
|
CNS 15648
2019 Edition Silica fume used in cementItious mixtures 膠結混合料用矽灰 |
|
|
|
CNS 5819
2019 Edition Method of Test for Silica Powder (WhIte Carbon) 二氧化矽粉（橡膠用）檢驗法 |
Translated |
|
|
CNS 15203
2019 Edition Oils of bergamot, lemon, cItron and lime, fully or partially reduced in bergapten - Determination of bergapten content by high-pressure liquid chromatography (HPLC) 香檸檬油、檸檬油、柑橘油及萊姆油－香檸檬烯含量測定高效能液相層析法（ＨＰＬＣ） |
|
|
|
CNS 15200-1-6
2019 Edition Testing methods for paints - Part 1-6: General rule - Temperatures and humidIties for conditioning and testing 塗料一般試驗方法－第１－６部：通則－調節與試驗之溫度及濕度 |
|
|
|
CNS 14432-2
2019 Edition Determination of the ultimate aerobic biodegradabilIty of plastic materials under controlled composting conditions − Method by analysis of evolved carbon dioxide − Part 2: Gravimetric measurement of carbon dioxide evolved in a laboratory-scale test 塑膠材料在控制堆肥條件下最終好氧生物分解度測定法－二氧化碳釋出量分析法－第2部：實驗室規模重量測定法 |
|
|
|
CNS 15449-2-101
2019 Edition Safe requirements for electrical for measurement, control and laboratory use ? Part 2-101: Particular requirements for in vItro diagnostic (IVD) medical equipment 量測、控制及實驗室使用電氣設備安全規定－第2-101 部:體外診斷(IVD)醫用設備之個別規定 |
|
|
|
CNS 15030-17
2019 Edition Classification and labelling of chemicals - Acute toxicIty 化學品分類及標示－急毒性物質 |
Translated |
|
|
CNS 15748-4
2019 Edition Integrated CircuIts – Measurement of electromagnetic emissions, 150 kHz to 1 GHz – Part 4: Measurement of conducted emissions – 1 Ω/150 Ω direct coupling method 積體電路－150 kHz 至1 GHz 電磁放射量測－第4 部：傳導放射量測－1Ω/150Ω直接耦合法積體電路－150 kHz 至1 GHz 電磁放射量測－第4 部：傳導放射量測－1Ω/150Ω直接耦合法 |
|
|
|
CNS 4063
2019 Edition Reinforced Concrete Covers for DItches (U Type) 鋼筋混凝土Ｕ形溝用蓋 |
Translated |
|
|
CNS 13306-1-4
2019 Edition Specification for radio disturbance and immunIty measuring apparatus and methods - Part 1-4: Radio disturbance and immunity measuring apparatus - Ancillary equipment - Radiated disturbances 射頻擾動和免疫力量測設備與量測方法－第１－４部：射頻擾動和免疫力量測設備－輔助設備－輻射擾動 |
|
|
|
CNS 14118
2019 Edition Emergency shut-off valves for nature gas wIth high pressure and intermediate pressure 高、中壓天然氣用緊急遮斷閥 |
|
|
|
CNS 15077-4
2019 Edition Test condItions for machining centers - Part 4 : Accuracy and repeatability of positioning of linear and rotary axes 切削中心機之檢驗條件－第４部：線性軸與旋轉軸之定位精度與重現性 |
|
|
|
CNS 13306-1-5
2019 Edition Specification for radio disturbance and immunIty measuring apparatus and methods - Part 1-5: Radio disturbance and immunity measuring apparatus - Antenna calibration test sites for 30 MHz to 1000 MHz 射頻擾動和免疫力量測設備與量測方法－第１－５部：射頻擾動和免疫力量測設備－30 MHz至 1000 MHz之天線校正場地 |
|
|
|
CNS 13018
2019 Edition Plastic film capacItors (characteristic S) for direct current 塑膠製平墊板 |
|
|
|
CNS 29182-1
2019 Edition Information technology − Sensor networks: Sensor Network Reference ArchItecture (SNRA) − Part 1: General overview and requirements 資訊技術－感測器網路：感測器網路參考架構(SNRA)－第1部：概觀及要求事項 |
|
|
|
CNS 12456
2019 Edition Corrosion InhibItor for Reinforcing Steel in Concrete 鋼筋混凝土用防銹劑 |
|
|
|
CNS 16083-2
2019 Edition ViscosIty and viscometric fixed points of glass − Part 2: Determination of annealing point and strain point by fiber elongation 玻璃黏度和黏度固定點－第2部：以玻璃絲拉伸法測定退火點和應變點 |
|
|
|
CNS 13306-2-3
2019 Edition Specification for radio disturbance and immunIty measuring apparatus and methods - Part 2-3: Methods of measurement of disturbances and immunity - Radiated disturbance measurements 射頻擾動和免疫力量測設備與量測方法－第２－３部：擾動和免疫力量測方法－輻射擾動量測 |
|
|
|
CNS 12544
2019 Edition Mechanical vibration and shock − Hand-arm vibration − Measurement and evaluation of the vibration transmissibilIty of gloves at palm of the hand 機械性振動及衝擊－手臂振動－在手套之手掌處的振動傳導率之量測及評估 |
|
|
|
CNS 15210-1
2019 Edition Information technology - Radio frequency identification for Item management - Part 1: Reference architecture and definition of parameters to be standardized 資訊技術－品項管理之無線射頻識別－第１部：參考架構及參數定義 |
|
|
|
CNS 13161
2019 Edition Codes for unIts of measure used in international trade 國際貿易之計量單位代碼 |
|
|
|
CNS 15646-2
2019 Edition Rigid cellular plastics – Determination of flexural properties – Part 2: Detrmination of flexural strength and apparent flexural modulus of elasticIty 硬質發泡塑膠－彎曲性能測定法－第2 部：彎曲強度與視彎曲彈性係數測定法 |
|
|
|
CNS 29182-5
2019 Edition Information technology − Sensor networks: Sensor Network Reference ArchItecture (SNRA) − Part 5: Interface definitions 資訊技術－感測器網路：感測器網路參考架構(SNRA)－第5部：介面定義 |
|
|
|
CNS 15593-61
2019 Edition ElectricIty metering – Data exchange for meter reading, tariff and load control – Part 61: Object identification system (OBIS) 電力計量－ 讀表、計費及負載控制之資料交換－ 第61 部： 物件識別系統(OBIS) |
|
|
|
CNS 11064
2019 Edition Injection Nozzle Holder Type P for Road Vehicles (wIth Body and with Fixing FLats) 汽車用Ｐ型燃料噴油嘴固定器 |
|
| Find out:3948Items | To Page of: First -Previous-Next -Last | [35] [36] [37] [38] [39] [40] [41] |
